Ultrasonic humidifier fogger REPTI PLANET

Model 007-52770

Status: New

It imitates morning fog in desert terrariums and simulates tropical fog in tropical terrariums.
Increases air humidity up to 100%, depending on the size of the terrarium.
With automatic protection against too low water level: if the water level drops (< 3 cm), the device will automatically turn off. Suitable not only for terrariums, but also for other water tanks. Great visual effect. REPTI PLANET – Membranes can be purchased separately as spare parts.

Note: Always make sure that the water level in the tank is high enough. Ultrasonic Fog Generator - Instructions for Use: This product produces cold fog using an ultrasonic ceramic disc (membrane) at normal temperature, which can increase the humidity in the terrarium (room) and produces negative ions to refresh the air. The product can also be used as a decoration - for example, a miniature fountain with an interesting fog effect.

Sequence of actions:

1. Place the generator flat in the water tank (the optimal water level is 20mm to 40mm above the ceramic disc).

2. Connect the generator power cable to the transformer. Connect the cable from the transformer to an electrical outlet. The device will begin to produce a water mist. At the same time, the LED will light up.

Comments:

1. Do not manipulate the device when connected to the power source, it may damage it.

2. The device should not work more than 10 hours a day.

3. Do not touch the ceramic disc (membrane) while the device is in use.

4. Only use clean water without impurities, contaminated water will shorten the operation time of the device.

5. Disconnect the power supply to the device before changing its position or maintenance.

6. Ceramic disc (membrane) is subject to natural wear, its usage time is about 3000 hours. If you notice a reduction in the amount of fog produced, clean the ceramic membrane with a cotton swab (do not use detergent). If there is even less fog after cleaning, replace the worn membrane with a new one.

7. When replacing the ceramic disc (membrane), refer to the instructions. Make sure that the inside of the device is completely dry and make sure that the ceramic disc (membrane) has the correct side (side without a black loop) facing up.

Parameters of the Fogger device